McGrane Locomotive Clock

Brand new here but have perused this site in the past and read some information from a gentleman who posted about the above captioned clock.Mine has just arrived and was perplexed as to how to access the movement,is the dial bezel a screw type or held in place by the spacers over the cannon?
Any guidance will be appreciated and if this gets through I can post some photos.
Regards,
Bruce

Thank you for the link, Mr. Buchan was the gentleman who has done the research and hopefully he still frequents the message board.
Regards,
Bruce

I tried to post the images and they exceed your size parameters.....
Bruce

In this link titled "HELP IN POSTING IMAGES FOR HOSTING ON OUR IHC185 DISCUSSION SITE" I have posted the following:


>> Proper size: 640 X 480 Pixels
>> Resolution: approximately 72 Pixels/Inch

.

Thanks, but that would mean I would have to reset all the image profiles................maybe send to someone who might be able to change and conform to the site requirements.
Bruce

Dr., I sent them twice hopefully they didn't end up in your trash bin.
Regards,
Bruce

Hi Bruce , I use my cell phone to take pictures ,upload to my google pictures , and post . I was resizing it but think this is easier

Thanks for the tip Kevin, I have sent them twice as I mentioned and they were going to be resized and posted and also nothing from Mr. Buchan.....oh well,I have solved the question of the dial bezel myself.
Bruce

Hi, I just resent the photos,the original address had the IHC in lower case,i.e., ihc so I used upper case this time.
Bruce

Would any member have a wooden stand that might fit this clock?
Thanks,
Bruce