WWT Shows CLICK TO: Join and Support Internet Horology Club 185™ IHC185™ Forums

• Check Out Our... •
• TWO Book Offer! •
Go
New Topic
Find-Or-Search
Notify
Tools
Reply to Post
  
Another Fusee Question "Click" to Login or Register 
IHC Life Member
Site Moderator

Picture of Tom Brown
posted
I started to disassemble another verge fusee movement but when I got to the fusee itself to disassemble to clean I can't figure this one out.

It had a screw that held the top piece on, but the underneath where I have always found a pin that had to be removed, this one is solid with no pin hole or pin. It would appear that perhaps the entire shaft comes out some how. Any suggestions on how to proceed, the fusee ratchets fine but I like to clean & re-oil them.

Below I will post a photo of each end of the fusee.

Thanks

Tom

01
 
Posts: 5107 | Location: New Mexico in the USA | Registered: January 27, 2007
IHC Life Member
Site Moderator

Picture of Tom Brown
posted
The bottom

02
 
Posts: 5107 | Location: New Mexico in the USA | Registered: January 27, 2007
  Powered by Social Strata  
 


©2002-2023 Internet Horology Club 185™ - Lindell V. Riddle President - All Rights Reserved Worldwide

Internet Horology Club 185™ is the "Family-Friendly" place for Watch and Clock Collectors